Autostart as2520 Installationsanleitung PDF herunterladen (Seite 6)

P. 6 Installation Guide

12-Pin Accessories Harness

Wire Colour Function Description

1 BLUE

(–) Trunk /

AUX 3 output

500 mA negative output. This output can be used to control the

trunk release (1-sec. pulse), or it can be set to operate as a

constant output as long as the

TRUNK button is held pressed

(for sunroof or window closure)

2 BROWN

(–) Lock

output

Programmable 500 mA negative output: 1/10-sec., 7/10-sec. or

4-sec. pulse

3 GREEN

(–) Unlock

output

Programmable 500 mA negative output: 1/10-sec., 7/10-sec.,

4-sec. or double 1/4-sec. pulse (

ON 250 ms, OFF 500 ms, ON

250 ms).

WHITE /

BROWN

(–) Rearm

output

500 mA ground signal when the doors are locked by remote

control. This wire will go to ground 1/2 sec. before the

LOCK

pulse, and go out 1/8 sec after

LOCK. The wire must be

connected to the OEM arm wire (usually the door pin).

Note: The module will also give a rearm pulse on this wire

when it shuts down the vehicle after a remote start.

WHITE /

GREEN

(–) Disarm

output

500 mA ground pulse when the doors are unlocked by remote

control. Connect to the OEM disarm wire of the vehicle.

Note: The system will also give a disarm pulse on this wire

before every remote start.

BLUE /

WHITE

(–) AUX 1

output

Depending on the configuration of Mode 3, Function 4 (see

programming options), this output will provide either a

500 mA ground output on the 2

consecutive press of the

UNLOCK button to unlock all doors, or a horn confirmation on

the first or second press of the

LOCK button.

WHITE /

ORANGE

(–) Starter kill

output

(armed output)

This wire will provide a constant 500 mA output when the

system is armed (locked by remote control). It can be

connected to an external starter interrupt relay.

This wire should be connected to a single pole double-throw

relay: this wire will connect to pin 85 on the relay, and pin 86

will be connected to the ignition wire.

The starter kill output becomes active during remote starts.

One benefit of the starter kill is the anti-grind feature. Once the

vehicle has been remote started, the anti-grind prevents the

starter motor from re-engaging when the ignition key is

inserted in the ignition switch and accidentally turned to the

CRANK position.

8 ORANGE

(–) AUX 2

output

This negative 500 mA output can be programmed for one of

the following options:

1. Constant while the FUNCTION and LOCK buttons are

pressed + 1 sec after release of the buttons.

2. FUNCTION + LOCK toggles ON / OFF (max. 30 sec.).

3. FUNCTION+ LOCK toggles ON / OFF (max. 4 minutes Æ

Only when running under a remote start).

4. Priority door access (2

press of UNLOCK to unlock all

other doors). Refer to Priority Door section on page 17

for more detail.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

Autostart as2520 Installationsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedingungen Autostart as2520