Autostart as2520 Installationsanleitung PDF herunterladen (Seite 10)

The Programming Assistance Button

(A.k.a. the PAB.) Mounted on the module, this

button can be used from within the vehicle instead of

the hood pin switch in the engine compartment. This

will spare the installer the trouble of accessing the

hood pin switch in the engine compartment.

Caution: The hood pin switch must be installed and connected in order for the programming

assistance button to function. The button will work only when the hood is up.

Programming the Transmitter

Before you proceed

The transmitter of the module is not delivered pre-programmed: it must be programmed after the

wiring of the module is completed. The module has the ability to retain up to 4 different transmitter

codes; if a fifth transmitter is programmed, the code of the first transmitter will be lost from memory.

To erase all transmitter codes from memory, you must perform a reset of the module (see

Resetting the Module on page 17, for more details).

The Transmitter Programming Procedure

1. Flash the hood pin switch (see page 9)

– The parking lights will stay ON for up to 20 seconds.

– Before the lights go out, turn the ignition key to the IGNITION ON (RUN) position.

– Immediately turn the ignition key back to the OFF position.

2. Press and hold the LOCK button until the parking lights flash 5 times quickly.

– The module has stored the code of the transmitter into memory.

3. To exit: close the hood.

Programming a Transmitter

To program a transmitter on the second vehicle for multi-car operation, you must press the

TRUNK

button (instead of LOCK or UNLOCK) in step 2 of the transmitter programming procedure:

Entering Programming Options Mode

The module is equipped with four custom programming modes that allow the installer to custom-fit

the system outputs according to installation requirements. The programming options are designed

to facilitate interfacing with all vehicle types. To enter the programming center, follow either

procedure (Table 1 or Table 2); please note that the second procedure requires the use of the

plug-in valet:

P. 10 Installation Guide

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Keine Kommentare

Autostart as2520 Installationsanleitung Seite 10