Autostart as2520 Installationsanleitung PDF herunterladen (Seite 11)

Installation Guide P. 11

1. Flash the hood pin switch (see page 9)

– The parking lights will stay ON for up to 20 seconds.

– Before the lights go out:

2. Press and hold the brake pedal,

– And press one of the following buttons on the transmitter:

• LOCK to access mode 1;

• UNLOCK to access mode 2;

• TRUNK to access mode 3;

• START/STOP to access mode 4.

The parking lights will flash and the horn will honk once (if configured), twice three times or

four times to confirm entry into a mode.

3. Release the brake pedal.

4. To exit programming centre, simply close the hood.

Table 1

To get into the programming centre

Note: The unit will stay in the selected programming mode until the hood pin-switch or the brake

pedal is pressed again. Therefore take your time to make the proper selection. Pressing the

brake pedal will take you back to the programming centre, where you can select a different mode.

1. With the key inserted in the ignition switch, turn the key from the OFF position to the ON position

and then back to the OFF position.

2. Press and hold the valet switch for three (3) seconds.

3. The LED will turn ON solid.

4. Press and hold the brake pedal,

– And press one of the following buttons on the transmitter:

• LOCK to access mode 1;

• UNLOCK to access mode 2;

• TRUNK to access mode 3;

• START/STOP to access mode 4.

The parking lights will flash and the horn will honk once, twice, three or four times to confirm entry

into a mode (if the horn is configured).

5. Release the brake pedal.

6. To exit the programming centre, press and hold the brake pedal for three (3) seconds.

Table 2

To get into the programming centre

Once you access a particular programming mode, you will automatically start at function 1. Once

you select one of the options of function 1, you will automatically be taken to the next function.

To select one of the five options of any given function, press the corresponding button on the

transmitter:

• LOCK button .............................to access option 1

• UNLOCK button .........................to access option 2

• TRUNK button ...........................to access option 3

• START button ............................to access option 4

• FUNCTION then LOCK buttons .....to access option 5

Accessing options

In each function, once an option has been selected the parking lights will flash 1, 2, 3, 4 or 5 times

(depending on the selected option).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

Autostart as2520 Installationsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedingungen Autostart as2520