Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either
Remember: Once the Parking Lights are on Solid, you have up to 20 seconds to select a sub-menu. Failure to do so will result in the Module exiting th
CT-5000 Installation Guide P.11 The Parking Lights and the Siren will flash and chirp once, twice or 3 times to confirm entry into a Mode. 3. Releas
P.12 Installation Guide CT-5000 Car Finder disabled. O Constant output while PTION 3 pressed (press LOCK and UNLOCK) Car Finder disabled. O
CT-5000 Installation Guide P.13 OPTION 2* Shock Sense - monitored / Warn Away – monitored OPTION 3 Shock Sense - Monitored / Warn Away – ignored OPT
P.14 Installation Guide CT-5000 Table 5 Multi-SNo manual adjustments are necessary. How hould go through the Tach programming procedure every time a
CT-5000 Installation Guide P.15 Away. A medium “tap” should trigger the Warn Away. A hard “tap” should trigger the Alarm. • All vehicles are diffe
Caution! Do not use more than one of the three sets of jumper pins simultaneously. The relay output rating on this Unit is 25A max output. Defective
CT-5000 Installation Guide P.17 Safe Start (Child Safety Mode) (OFF by default.) Requires the user presses the START/STOP button on the Transmitter t
P.18 Installation Guide CT-5000 Disarmed Notification This feature will notify the user when the vehicle is left disarmed after Ignition is turned of
CT-5000 Installation Guide P.19 • The Parking Lights and L.E.D. will flash the five events stored in memory. The first four playback codes are Start
P.2 Installation Guide CT-5000 Table of Contents Introduction... 2 Included in the Package ...
P.20 Installation Guide CT-5000 − It always better to strip more than you need, than not enough. A common way cold solder joints happen is when not
CT-5000 Installation Guide P.21 made. This extra bit wire is wrapped around the exposed OEM wire to secure in place while you are soldering. − When
P.22 Installation Guide CT-5000 85 & 86: The Coil. These inputs energize the coil when one is +12 Volts, and the other is Negative. They are usua
CT-5000 Installation Guide P.23 Problem: You need to power Multiple Ignition wires to remote start the vehicle, but your module only has one Ignition
P.24 Installation Guide CT-5000 Example: Activating a Positive Trunk release switch Problem: The vehicle's power trunk release switch is ac
CT-5000 Installation Guide P.25 86: Connects to a fused +12 Volt source. 87: Connects to a Negative source. i.e. The spot where the remote start mo
P.26 Installation Guide CT-5000 • Are you waiting too long between programming steps? ¾ After flashing the hood pin turn the key to ON, WAIT for 2 s
CT-5000 Installation Guide P.27 14. The CHECK ENGINE light comes on and the vehicle doesn't shift, it feels sluggish. • Missing second ignition
P.28 Installation Guide CT-5000 28. I blow fuses every time I try the remote trunk release and I have already installed a relay. • Trunk release is
CT-5000 Installation Guide P.29 Diagnostics - Parking Lights Flash Rate Flashes Description 1 • Doors locked, Starter Kill armed. • End of Run Time
CT-5000 Installation Guide P.3 1 – six-pin 14 AWG Harness (Ignition Harness) 1 – five-pin 18 AWG Harness (Main Harness) 1 – twelve-pin 22 AWG Harne
P.4 Installation Guide CT-5000 ♦ Make sure that all safety equipment is installed: the Valet Button, the Hood Switch and the warning label ♦ When wir
CT-5000 Installation Guide P.5 WIRES at the IGNITION switch, this will compromise the OEM electrical system. E ORANGE (+) 30 A Accessories output Thi
P.6 Installation Guide CT-5000 12-Pin Accessories Harness Wire Description 1 BLUE (–) AUX 3 (Trunk) output 500 mA negative output. This output can
CT-5000 Installation Guide P.7 10 WHITE (–) Ground out when running This is a 500-mA constant ground output that is active when the vehicle is running
P.8 Installation Guide CT-5000 12 YELLOW (+) Glow-plug Light input This positive input will monitor the Glow Plug Light in Diesel Mode: it will wait
CT-5000 Installation Guide P.9 2-Pin Harness Wire Description 1 BLUE / WHITE ( -) AUX 2 output • 500 mA negative output. Can be programmed for one
Kommentare zu diesen Handbüchern