Notice The manufacturer will accept no responsibility for any electrical damage resulting from improper installation of the product, be that either d
The Installer … The Module … 1- Press and hold the Hood pin for 4 seconds.2- Let go of the Hood Pin. Parking Lights “ON”3- While the Parking Lights
AS-1535 SH Installation Guide P.11The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is programmed, the
P.12 Installation Guide AS-1535 SHOptions Programming MODE 1 *indicates default setting FUNCTION 1 – Ignition-controlled Door Locks OPTION 1* Ig
AS-1535 SH Installation Guide P.13OPTION 2* Disabled OPTION 3 Disabled MODE 3 *indicates default setting FUNCTION 1 – Home Valet Mode OPTION 1 H
P.14 Installation Guide AS-1535 SHClose the Hood to cancel the changes. Table 4 Auto Tach Programming Procedure This process can be carried out inste
AS-1535 SH Installation Guide P.152. Test Hood Switch shutdown: with the vehicle running under the Remote Starter, open the Hood; the vehicle should
Caution!Do not use more than one of the threesets of jumper pins simultaneously.The relay output rating on this Unit is25A max output. Defective OEMso
AS-1535 SH Installation Guide P.17Turbo Mode This Option allows turbochargers to idle down: after the user leaves the vehicle, the Engine will keep r
P.18 Installation Guide AS-1535 SHx With the Parking Lights on, immediately push the Pin-switch 3 times.x The Parking Lights and L.E.D. will flash th
AS-1535 SH Installation Guide P.19Note: “x” stands for one flash of the Parking Lights Diagnostics - Parking Lights Flash Rate Flashes Description 1
P.2 Installation Guide AS-1535 SHTable of Contents Introduction... 3Included in the Package ...
AS-1535 SH Installation Guide P.3Introduction This Guidebook contains all information pertinent to the installation. Most (if not all) features are
P.4 Installation Guide AS-1535 SHƇ Never leave the keys in the car. Leave them on a workbench with a window rolled down. Ƈ Remove courtesy light fuse
AS-1535 SH Installation Guide P.56-Pin Main Ignition Harness Wire Description ARED+12 V BatteryConnect to the largest 12 V supply wire at the Ignitio
P.6 Installation Guide AS-1535 SHNOTE: A Tach signal that is too low will cause the Module to “over crank” and a Tach signal that is too high will ca
AS-1535 SH Installation Guide P.77WHITE / ORANGE(–) Starter Kill output The unit is equipped with a selectable passive- or active-arming Starter Ki
P.8 Installation Guide AS-1535 SH9(cont.)PURPLE(-) External Trigger Option 3 (Key Sense (-) Input): Connects to OEM Key Sense Wire.When the Key is de
AS-1535 SH Installation Guide P.912(cont.)YELLOW(+) Glow-plug Light input (cont.) A diode must be added between the negative Glow-plug trigger on th
Kommentare zu diesen Handbüchern