Autostart AS-6205i SH Bedienungsanleitung PDF herunterladen

Diagnostics - Parking Lights Fiash Rate

Flashes Description

• Doors locked, Starter Kill armed.

• End of Run Time.

• TRUNK button pressed

• START signal received by the Module.

• Cold Weather Mode cancelled.

• Cannot start after maximum number of attempts Is reached.

• Run Time cancelled

• Remote start attempt cancelled by remote

• Doors unlocked, Starter Kill disarmed.

• Exiting remote valet

• Exiting Ignition Valet

• Entering Cold Weather Mode

• Entering remote valet

• Entering Ignition valet

• Extended runtime

• +12 volts detected on the Brake line; cranking cancelled

• Entering Tach Learning

• New Transmitter learnt

• Tach learnt

• Remote start attempt was made with a Tach or a vacuum signal detected before

cranking

• Unit reset: occurs when the unit Is reset to factory defaults

• The Hood Switch line went to ground during cranking or run time

1 - pause -

• There was an attempt to start the vehicle while the Module was In Valet Mode.

2 - pause -

• There was an attempt to start the vehicle while the Module was In Home Valet

Mode.

ON solid

• Cold Weather Mode: the Brake Pedal Is being held down

ON 2 sec.

• The Hood Is up and the Hood Switch line went to ground. This Is step one of the

Programming Mode

ON 3 sec.

• First press of the START button under Safe Start.

• Entering Home Valet Mode

ON 4 sec.

• LOCK or UNLOCK pulse (If door pulse Is configured to 4 sec.)

ON 25 sec.

• If the Hood PIn-swItch has been pressed twice: the Unit went Into step 1 of the

Programming cycle and no Transmitter activity was detected for 20 seconds

• Or the Unit went Into step 1 of the Transmitter Code Learning procedure and no

activity was detected for a few seconds. The Unit has exited the Transmitter Code

Learning procedure.

Irregular

• If the Module gives Irregular flashes (1 to 10 flashes followed by a pause, followed

by more flashes), It Is In Playback Mode. This occurs when the Hood-switch line Is

flashed 3 times.

Constant

flashes

up to 30 sec.

• Panic Mode set off.

P.20 Installation Guide AS-6205Í SH

AUTOMATIC TRANSMISSION REMOTE STARTER

SYSTEM

AS-6205Ì SH

Instaiiation Guide

Notice

The manufacturer will accept no responsibility for any electrical damage resulting from

improper installation of the product, be that either damage to the vehicle itself or to the

Unit. This Unit must be installed by a certified technician using all safety devices

supplied. Please note that this guide has been written for properly trained Autostart

technicians, a certain level of skill and knowledge is therefore assumed. Please review

the Installation Guide carefully before beginning any work.

Warning

This unit is designed for vehicles with an automatic Transmission only.

Before installing the Unit, test that the vehicle will not start if the gear select lever is in the

“Drive” position. If the vehicle starts in gear, install a manual-transmission Car Starter

instead.

H.310 S.3.20 DOC: 1.00 CA - October 10, 2006 Manufactured In Canada by Autostart

1 2 3 4 5 6 7 8 9 10

Inhaltsverzeichnis

Seite 1 - AS-6205Ì SH

Diagnostics - Parking Lights Fiash RateFlashes Description1• Doors locked, Starter Kill armed.• End of Run Time.• TRUNK button pressed• START sign

Seite 2

The Programming Assistance Button (A.k.a. PAB.)The PAB is located on the side of the Module. This push button mimics the Hood-Pin switch

Seite 3

Table of ContentsIntroduction...3Included in the Package...3Befo

Seite 4 - Installation Guide P.17

Disarmed NotificationThis feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or when the Modu

Seite 5 - 5-Pin Secondary Harness

Before You Get Stsrted...♦ On vehicles with a manual Transmission, always ensure that all Doors will get the Unit out of Ready Mode. Sw

Seite 6 - Installation Guide P.15

Caution!Do not use more than one of the three sets of jumper pins simultaneously.The relay output rating on this Unit is 25A max outp

Seite 7 - Multi-Speed Tach Programming

“under crank”.3gray(-) Hood Switch inputConnect this wire to the Hood Pin-switch supplied. This input will disable or shut down the Rem

Seite 8 - 2-Pin Harness

Table 5Multi-Speed Tach ProgrammingNo manual adjustments are necessary. However, you should go through the Tach programming procedure every

Seite 9 - Flashing the Hood Pin

12YELLOW (+) Glow- plug Light InputThis positive input will monitor the Glow Plug Light in Diesel Mode: it will wait until the Glow Plug L

Seite 10 - *indicates default setting

All Doors unlock upon the 2"^ , 4“i, 6“i > pressing of the UNLOCK button.Mode 2‘Indicates default settingFunction 1 - Home Valet ModeOPTION 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Autostart AS-6205i SH Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Autostart AS-6205i SH herunter. Autostart AS-6205i SH User Manual [de] Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Autostart AS-6205i SH